Maxi-Cosi FERO - ANNEXE 7 Manual do Utilizador Página 41

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 134
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 40
Section 1. GENERAL DESCRIPTION AND TECHNICAL DATA 41
1.10 Aligning the arm with the machine X axis
After fixing the arm in the machine, align the cube parallel with the machine X axis.
Align the stylus as follows:
1. Loosen the two screws (a) at the slotted holes in the arm connecting base and maintain some
friction on the lower screw (b) (pivot).
2. Turn the arm relative to the screw (b), bringing the stylus parallel with the machine X axis. The
parallelism between the stylus and the machine X axis must be 0.05mm (see Figure 1-8).
3. Tighten the 3 screws fully home and check that the alignment was not changed by this tightening.
4. Put the base in position. Drill holes in the support through the base, using the holes (c) in the base
as a guide. Insert the cylindrical pins supplied in the Kit, then apply an anti-corrosive treatment.
Figure 1-8. Aligning the arm.
Figure 1-9. Pinning.
Lathe axis
Drill bit
Cylindrical pin
Vista de página 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 133 134

Comentários a estes Manuais

Sem comentários